2026 Superflex Fantasy Football Cheat Sheet

2QB Strategy

A superflex cheat sheet is a rankings board adjusted for leagues that let you start a second quarterback in your flex slot, the format most sites sell as 2QB. In single-QB leagues you can wait on quarterback. In superflex you cannot. Only 32 quarterbacks start each NFL week, and a 12-team 2QB league needs 24 starting passers before a single backup comes off the board, so QBs climb quickly. On our projection-based board, 22 of the first 23 players drafted are quarterbacks, running from Jalen Hurts at 1.1 through Lamar Jackson at 23.1. This 2026 superflex cheat sheet tiers the top 40 by adjusted ADP and marks where each positional cliff sits, so you know when to take your second passer and when to let the QB run move past you. Positional value shifts behind those tiers were measured across seven seasons of nflverse scoring data covering 1,303 distinct players from 2018-2024 (Source: nflverse, 2018-2024).

The QB cliff in 2QB drafts

Our projections put Jalen Hurts, Joe Burrow, and Josh Allen in a tier of their own at 30.0, 30.0, and 29.6 projected points per game, with Patrick Mahomes just behind at 27.8. After that the group tightens instead of falling off a cliff: Jayden Daniels (27.2), Anthony Richardson (26.6), Jordan Love (26.4), and Tua Tagovailoa (26.3) all land within one point of each other. That compression is the real story of 2QB drafts. If you miss the top three, the penalty is roughly two and a half points per game, not a season-ender. The rushers carry extra insurance in superflex because their floor does not depend on a big passing day: Daniels projects 750 rushing yards and Richardson 650, while Burrow projects 150.

The full positional board with weekly ranks lives on our superflex rankings site if you want deeper QB data than this sheet covers.

Running backs and receivers after the QB run

Once the QB run ends, Bijan Robinson goes first among skill players at 24.2 on our board, followed by Jahmyr Gibbs at 25.2 and Ja'Marr Chase as the first receiver at 27.3. The depth profile differs by position. The first 12 running backs span picks 24.2 to 57.8, a 33-pick spread. The first 12 receivers span picks 27.3 to 53.6, a tighter 26-pick spread, and the receiver pool stays useful deeper into the draft than any other position. Practical read for superflex: spend your first two picks on quarterbacks, then work the receiver tiers while other managers keep chasing passers you already own. The backs thin out faster, so circle the second tier of runners rather than waiting on a third. In our 7,208-draft two-QB average-position sample, the RB12 comes off roughly two rounds after the QB12, which means every quarterback you add pushes usable runners toward your middle-round picks. That is the structural trade superflex managers accept: elite passer production early, then a receiver-heavy middle built from the 26-pick tier window, and running back depth assembled from rounds 8 through 12 where the positional drop-off flattens. Plan those three phases before you draft and the board stops surprising you.

Tight end can wait in this format

Tight end is the last position to come off the board here. Travis Kelce is the first tight end at 76.7, Brock Bowers follows at 88.2, and Dalton Kincaid, Trey McBride, Mark Andrews, George Kittle, and Sam LaPorta all sit between 95 and 108. Because your early capital goes to quarterbacks in superflex, paying a premium for a tight end means starting the draft with only one skill player through five rounds. The gap between the TE2 and TE7 on our board is under 13 picks, which says the position offers little edge for reaching. Take a passer instead and grab your tight end when the run starts, not before. One caveat from the 2026 board: Travis Kelce and Brock Bowers are the only tight ends projected inside the top 90 overall, so a late first-round tight end run is a real possibility if two or more managers break the pattern. If you miss both, the 13-pick gap between the TE2 and TE7 means the replacement cost is a mid-round pick, not a premium one. That asymmetry is why the wait strategy holds in superflex even when the position looks top-heavy.

Superflex draft FAQ

When should I draft a QB in superflex?

Target your first quarterback inside the first four rounds and your second by round six. On our board the top six passers all go inside pick 7, and 22 of the first 23 picks are quarterbacks, so waiting longer means drafting from the 26-point tier instead of the 30-point tier.

How many quarterbacks should I roster?

Two starters at minimum. In 10-team and larger leagues, carry a third as a bye-week fill and trade chip, because your leaguemates will run short on starters by midseason.

Is superflex the same as 2QB?

Almost. A 2QB league requires two quarterbacks in your lineup. Superflex lets you start any position in the flex, but starting a second QB is almost always the right call, so draft strategy is effectively identical.

What if I miss the early QB run?

The QB8 through QB12 group on our board, Jordan Love through Brock Purdy, projects within 1.6 points per game of each other. Load up on running backs and receivers while that tier is still there, then take whichever passer falls to you. Waiting costs you about two and a half points per game versus the top three, not your season.

Do kickers and defenses matter more in superflex?

No. The format changes quarterback and skill-position value only. Draft kickers and defenses in the final rounds exactly as you would in a one-QB league.